PDF A4: materiais, cada carreira com caixinha, montagem e rostinho
A free crochet Christmas ornaments pattern for a round hazel-brown hedgehog in a red Santa hat with a pompom and a golden hanging loop. This amigurumi hedgehog has a cream face, a dark little nose, round ears and a back covered in short yarn fringe quills that make it look spiky and soft at once. It is worked in the round in single crochet with fingering yarn and a 2 mm hook and stands about 9.3 cm (3.7 in) tall with the hat; the eyes are embroidered, the face, snout, ears, feet and hat are sewn on and the quills are knotted in. The page gives a row-by-row pattern with stitch counts and an interactive 3D model to check every piece.
Como fazer Hedgehog in a Santa Hat Ornament de crochê
Intermediário · 9 cm de altura · cerca de 2 h · fio fingering · agulha de 2 mm
Faça as 13 partes em carreiras: Head-body ball, Cream face, Snout, Nose, Ear ×2, Cheek ×2, Foot ×2, Santa hat, Pompom, Hanging loop (67 carreiras no total).
Encha e monte em 10 etapas; cada uma acende no modelo 3D onde a parte vai.
Faça o rostinho: olhos de segurança por carreira e ponto, ou bordados para menores de 3 anos.
Cada carreira com o número de pontos está na aba Receita abaixo e no PDF grátis para imprimir.
1 sc ≈ 3 mm wide, 1 round ≈ 2.7 mm tall (10 cm ≈ 33 sc × 37 rounds); yarn about 1.4 mm thick. The gauge sets the size of the toy; crochet tightly so the stuffing does not show.
Como é feito
Carreiras contínuas em espiral. Não feche as carreiras. Suba o marcador a cada carreira.
Size before assembly: about 5.4 cm at the widest, 5.4 cm long; 26 rounds.
→ Start stuffing (firmly) and keep adding as you decrease.
Top up the stuffing if needed. Fasten off leaving a 15 cm tail; with the needle weave it through the front loops of all 6 stitches of the last round, pull tight and hide the end inside.
A flat oval about 4.2 × 2.7 cm; 5 rounds.
Worked around a chain, so it is an oval: sew it on with its long side (along the chain) running side to side. The round-start marker is in the middle of a long side (the piece's centre line), while R1 starts at a turn: after R1 shift the round start — sc 2 more (not counted in any round) and place the marker there. The increases fall on the turns.
With cream: ch 7.
Fasten off leaving a long tail (30–40 cm) for sewing.
Do not stuff.
Size before assembly: about 1.2 cm at the widest, 0.9 cm long; 4 rounds.
Fasten off leaving a long tail (30–40 cm) for sewing.
Stuff lightly just before sewing it on; a little less near the edge, then add a pinch when the seam is nearly done.
Size before assembly: about 0.8 cm at the widest, 1 cm long; 4 rounds.
→ Start stuffing (firmly) and keep adding as you decrease.
Top up the stuffing if needed. Fasten off leaving a 15 cm tail; with the needle weave it through the front loops of all 4 stitches of the last round, pull tight and hide the end inside.
Size before assembly: about 1.7 cm at the widest, 0.9 cm long; 4 rounds.
Fasten off leaving a long tail (30–40 cm) for sewing.
Do not stuff. Shape it into a dish: rounds 1–2 are the front of the piece, the magic ring its centre. Push the centre in so the front is concave (about 1.4 mm at the centre) and turn rounds 3–4 to the back: they make a thick rounded rim (about 5.9 mm thick) and lie behind as a second layer; the piece is about 17 mm across.<!-- (dish 50 %) -->
A flat circle about 1 cm across; 2 rounds.
Fasten off leaving a long tail (30–40 cm) for sewing.
Do not stuff.
Size before assembly: about 0.8 cm at the widest, 0.7 cm long; 3 rounds.
Fasten off leaving a long tail (30–40 cm) for sewing.
Stuff lightly only and press it flat to about 4 mm thick.<!-- flattened 50 % -->
Size before assembly: about 3 cm at the widest, 2.2 cm long; 10 rounds.
Change to snow white (pull it through on the last yarn-over of R7).
Fasten off leaving a long tail (30–40 cm) for sewing.
Do not stuff.
Bend ≈ 30° around round 5<!-- the bend spreads over 3 rounds -->. Bend the piece so the inner side of the bend faces backward on the finished toy (on the piece: in round 5, on the centre back line). On the inner side draw rounds 4 and 6 together (2 rounds go into the fold): with the needle and matching yarn make 3–4 stitches through the loops of both rounds over about 6 st, pull to the angle and hide the end inside.
Size before assembly: about 1.4 cm at the widest, 1.7 cm long; 7 rounds.
→ Start stuffing (firmly) and keep adding as you decrease.
Top up the stuffing if needed. Fasten off leaving a 15 cm tail; with the needle weave it through the front loops of all 6 stitches of the last round, pull tight and hide the end inside.
Size before assembly: about 1.5 cm at the widest (lies flat); 2 rounds.
Each piece is two circles (front and back): make 2 circles — 1 as below and 1 plain in soft gold (same rounds, no colour changes).
Fasten off. Hold a front and a plain circle wrong sides together and sc around through both layers: 16 sc. Do not stuff. Leave a long tail (~30 cm) for sewing.
The whole face is embroidered. Order: the eyes (black satin), then the white glints over them, then the nose and mouth, blush last. Mark the centres with pins first and compare with the picture. Bring thread ends out where a sewn-on piece will cover them, or bury them in the stuffing.
Embroidered eyes (on the cream face) (2, symmetric: the toy's left side is described, the right is its mirror image): in black thread, a oval about 4.4 mm wide and 5.2 mm tall, horizontal stitches; centred between rounds 2 and 3, 3 st from the centre top line, toward the toy's left .
Eye glint (on the cream face) (2, symmetric: the toy's left side is described, the right is its mirror image): in snow white thread over the embroidered eye, a oval about 1.8 mm wide and 1.8 mm tall, horizontal stitches; centred between rounds 2 and 3, 3 st from the centre top line, toward the toy's left , then moved 0.8 mm to the right and 1.3 mm up (looking at the toy's face).
Mane (on the head-body ball): cut 12 pieces of yarn (dark brown, hazel brown) about 34 mm long; fold each in half and attach with a lark's head knot (pull through a stitch with the hook) along between rounds 9 and 10, 11 st from the centre front line, toward the toy's left -> between rounds 9 and 10, 4.5 st from the centre back line, toward the toy's left -> between rounds 9 and 10, on the centre back line -> between rounds 9 and 10, 4.5 st from the centre back line, toward the toy's right -> between rounds 9 and 10, 11 st from the centre front line, toward the toy's right , evenly spaced. Trim to about 7 mm.
Mane (on the head-body ball): cut 14 pieces of yarn (hazel brown, hazel brown) about 34 mm long; fold each in half and attach with a lark's head knot (pull through a stitch with the hook) along between rounds 11 and 12, 13 st from the centre front line, toward the toy's left -> between rounds 11 and 12, 5.5 st from the centre back line, toward the toy's left -> between rounds 11 and 12, on the centre back line -> between rounds 11 and 12, 5.5 st from the centre back line, toward the toy's right -> between rounds 11 and 12, 13 st from the centre front line, toward the toy's right , evenly spaced. Trim to about 7 mm.
Mane (on the head-body ball): cut 10 pieces of yarn (dark brown, hazel brown) about 34 mm long; fold each in half and attach with a lark's head knot (pull through a stitch with the hook) along between rounds 13 and 14, 14.5 st from the centre front line, toward the toy's left -> between rounds 13 and 14, 6 st from the centre back line, toward the toy's left -> between rounds 13 and 14, on the centre back line -> between rounds 13 and 14, 6 st from the centre back line, toward the toy's right -> between rounds 13 and 14, 14.5 st from the centre front line, toward the toy's right , evenly spaced. Trim to about 7 mm.
(on the head-body ball): cut 12 pieces of yarn (hazel brown, hazel brown) about 34 mm long; fold each in half and attach with a lark's head knot (pull through a stitch with the hook) along between rounds 15 and 16, 14.5 st from the centre front line, toward the toy's left -> between rounds 15 and 16, 6 st from the centre back line, toward the toy's left -> between rounds 15 and 16, on the centre back line -> between rounds 15 and 16, 6 st from the centre back line, toward the toy's right -> between rounds 15 and 16, 14.5 st from the centre front line, toward the toy's right , evenly spaced. Trim to about 7 mm.
Head-body ball · R1–R5
Ninguém mostrou o seu ainda. Seja a primeira pessoa.
Mane (on the head-body ball): cut 14 pieces of yarn (dark brown, hazel brown) about 34 mm long; fold each in half and attach with a lark's head knot (pull through a stitch with the hook) along between rounds 17 and 18, 13 st from the centre front line, toward the toy's left -> between rounds 17 and 18, 5.5 st from the centre back line, toward the toy's left -> between rounds 17 and 18, on the centre back line -> between rounds 17 and 18, 5.5 st from the centre back line, toward the toy's right -> between rounds 17 and 18, 13 st from the centre front line, toward the toy's right , evenly spaced. Trim to about 7 mm.
Mane (on the head-body ball): cut 10 pieces of yarn (hazel brown, hazel brown) about 34 mm long; fold each in half and attach with a lark's head knot (pull through a stitch with the hook) along between rounds 19 and 20, 11 st from the centre front line, toward the toy's left -> between rounds 19 and 20, 4.5 st from the centre back line, toward the toy's left -> between rounds 19 and 20, on the centre back line -> between rounds 19 and 20, 4.5 st from the centre back line, toward the toy's right -> between rounds 19 and 20, 11 st from the centre front line, toward the toy's right , evenly spaced. Trim to about 7 mm.
Mane (on the head-body ball): cut 12 pieces of yarn (dark brown, hazel brown) about 34 mm long; fold each in half and attach with a lark's head knot (pull through a stitch with the hook) along in round 21, 9.5 st from the centre front line, toward the toy's left -> in round 21, 4 st from the centre back line, toward the toy's left -> in round 21, on the centre back line -> in round 21, 4 st from the centre back line, toward the toy's right -> in round 21, 9.5 st from the centre front line, toward the toy's right , evenly spaced. Trim to about 7 mm.
Fringe (on the head-body ball) (2, symmetric: the toy's left side is described, the right is its mirror image): cut 3 pieces of yarn (dark brown) about 32 mm long; fold each in half and attach with a lark's head knot (pull through a stitch with the hook) along between rounds 14 and 15, 11 st from the centre front line, toward the toy's left -> between rounds 15 and 16, 13 st from the centre front line, toward the toy's left , evenly spaced. Trim to about 6 mm.
Fringe (on the head-body ball) (2, symmetric: the toy's left side is described, the right is its mirror image): cut 3 pieces of yarn (dark brown) about 32 mm long; fold each in half and attach with a lark's head knot (pull through a stitch with the hook) along between rounds 17 and 18, 10 st from the centre front line, toward the toy's left -> between rounds 18 and 19, 10.5 st from the centre front line, toward the toy's left , evenly spaced. Trim to about 6 mm.
Fringe (on the head-body ball) (2, symmetric: the toy's left side is described, the right is its mirror image): cut 3 pieces of yarn (dark brown) about 32 mm long; fold each in half and attach with a lark's head knot (pull through a stitch with the hook) along between rounds 20 and 21, 7.5 st from the centre front line, toward the toy's left -> between rounds 21 and 22, 9 st from the centre front line, toward the toy's left , evenly spaced. Trim to about 6 mm.
× scV incΛ dec
Abreviações
MR
magic ring
sc
single crochet
inc
2 sc in the same stitch
dec
single crochet two stitches together (invisible decrease recommended)
