Winnie-the-Pooh with a Honey Pot
- Difficulty
- 2/3
- Weirdness
- 1/5
- Times crocheted
- 0
Free crochet strawberry cow pattern: a Strawberry Cow Keychain amigurumi, about 5 cm tall in fingering yarn with a 2.0 mm hook. A tiny pink cow with raspberry strawberry spots, little ivory horns, a pale muzzle and a green leafy loop on top for your keys. You need about 50 m of yarn: 20 m pink, 5 m green, 5 m cream, 5 m ivory, 5 m raspberry, 5 m coral and 5 m salmon. Plan on roughly 2 hours. Clip it to a bag, a zipper or a set of keys, or hang it on a tree as a small ornament. You can spin the 3D model and follow the round-by-round pattern.
How to crochet the Strawberry Cow Keychain
Beginner-friendly · 5 cm tall · about 2 h · fingering yarn · 2 mm hook
- Crochet the 11 pieces in rounds: Head ball, Muzzle, Horn ×2, Ear ×2, Cheek ×2, Hoof foot ×2, Strawberry leaves (49 rounds in all).
- Stuff and put it together in 8 steps; each one lights up where it goes on the 3D model.
- Add the face: safety eyes by round and stitch, or embroider them for a child under 3.
Every round with its stitch count is in the Pattern tab below, and in the free printable PDF.
What you'll need
0 of 12 gathered
Gauge
1 sc ≈ 3 mm wide, 1 round ≈ 2.7 mm tall (10 cm ≈ 33 sc × 37 rounds); yarn about 1.4 mm thick. The gauge sets the size of the toy; crochet tightly so the stuffing does not show.
Worked in
Continuous spiral rounds. Don't join. Move a stitch marker up every round.
Parts
0 of 43 rounds done
- Size before assembly: about 4.9 cm at the widest, 3.7 cm long; 21 rounds. Multi-colour rounds are listed stitch by stitch from the round-start marker; keep the round start on the piece's centre front line (as it sits on the finished toy). The order is for right-handed crocheting (right to left on the outside); left-handed: reverse it.
- → Insert the safety eyes now (positions: see “Face”) and fix the backs. Start stuffing (firmly) and keep adding as you decrease.
- Top up the stuffing if needed. Fasten off leaving a 15 cm tail; with the needle weave it through the front loops of all 6 stitches of the last round, pull tight and hide the end inside.
- Size before assembly: an oval about 3.2 × 2.3 cm at the widest, 1.2 cm long; 6 rounds. The piece is oval: the rounds go around the chain, and on the finished toy the chain (the long side of the oval) runs side to side; the starting chain is at the front of the piece (on the finished toy). The round-start marker is in the middle of a long side (the piece's centre line), while R1 starts at a turn: after R1 shift the round start — sc 2 more (not counted in any round) and place the marker there. The increases fall on the turns.
- With cream: ch 5.
- Fasten off leaving a long tail (30–40 cm) for sewing. Stuff firmly just before sewing it on; a little less near the edge, then add a pinch when the seam is nearly done.
- Size before assembly: about 0.7 cm at the widest, 1.8 cm long; 7 rounds.
- Fasten off leaving a long tail (30–40 cm) for sewing. Stuff firmly just before sewing it on; a little less near the edge, then add a pinch when the seam is nearly done.
- Size before assembly: about 1.6 cm at the widest, 1.7 cm long; 7 rounds. Multi-colour rounds are listed stitch by stitch from the round-start marker; keep the round start on the piece's centre front line (as it sits on the finished toy). The order is for right-handed crocheting (right to left on the outside); left-handed: reverse it.
- Change to pink (pull it through on the last yarn-over of R6).
- Fasten off leaving a long tail (30–40 cm) for sewing. Stuff it lightly — a thin layer, just enough to hold the walls apart: the ear about 8 mm thick, with thick rounded edges. Then shape it into a spoon: push the front wall toward the back wall — a concave spoon about 1.4 mm deep in front, a rounded back; about 16 mm wide. Keep the opening a curve, hollow side forward, not a straight line.<!-- (spoon 40 %) -->
- A flat circle about 1 cm across; 2 rounds.
- Fasten off leaving a long tail (30–40 cm) for sewing. Do not stuff.
- Size before assembly: about 0.9 cm at the widest, 0.9 cm long; 4 rounds.
- Change to pink (pull it through on the last yarn-over of R2).
- Fasten off leaving a long tail (30–40 cm) for sewing. Stuff lightly just before sewing it on; a little less near the edge, then add a pinch when the seam is nearly done.
- Flat motif — star (worked in rounds, one layer of fabric), about 3 × 3.2 cm; 2 rows.
- Fasten off leaving a long tail (~30 cm) for sewing. Do not stuff. Weave in the starting tail, pin the motif out to shape on a soft surface and steam it lightly.
Nobody has shown theirs yet. Be the first.
Sign in to show yours
No questions yet
Ask the first one — the author and the AI helper both read here.
Make this toy yours
Open it in the 3D editor: change the colours, the size of any piece, or ask the AI in words. Your version gets its own pattern.
Try asking:
